This DIY Sissy Bar Kit gives you all the parts necessary to mount a sissy bar to pretty much any chopper. Just cut to length and weld!
Kit includes pre-bent sissy bar loop, 2 fender mount brackets (flat & arched), and pre-drilled axle plate mounts. The flat fender mount bracket is a perfect fit for our 5" flat Trailer Fenders and the arched bracket fits Gasbox 16" and 18" fenders, Stingray fenders, as well as old Ford '36 spare tire rings!
Made in AZ, USA.
Rev. R. Beck - 07/12/2014
Pros - Simple, straight forward kit!!
Cons - It's not twisted, chromed, and doesn't come with a machete scabbard welded in with a bronze Lemmy Killmeister topper already attached!!
Nice kit, universal fit! Had it measured, cut, welded and attached within 3-5 easy drinking garage hours! Do yourself a favor and buy it- it's easily kustomizable and coolificated!!!
Jamie - 04/26/2014
Pros - Well made,inexpensive
I consider myself a fabricator and welder. truth be told the cost of this kit was almost what the materials would have cost me to make it from scratch. plus my time to make it. When I first mounted it as per intended at the angle I wanted ther was no room to move the rear tire for chain adjustment. I removed the sissy bar and remade the fender mounting mounting system as well as the frame mounting. I also cut the bar in half and used it as struts rather than a sissy bar with the option of welding the top piece back on if I so decide before I send this out for chroming.. Over all this product is very well made and for the beginer or the hobiest it can be a do it your self kit in a couple of hours.
Ken - 12/25/2013
Pros - Easy setup, installation and all parts are included.
Cons - None
First of all, I'm not a fabricator by any means. I just like to get my hands dirty. So I ordered this kit for my Triumph and was a little worried about the rear wheel offset. I had a bit of a challenge with the fender brackets since the ones that it came with are for perfectly centered rear wheel. I massaged it a little using a vise, hammer and some 2x4 to unbend and rebend one of the brackets. Tacked and welded it all up then grinded and shaped the brackets for a cleaner look. Over all, it took me a couple evenings (after work) between measuring and assembly. I'm super happy with how it turned out and highly recommend this kit. I would definitely use it again in the future.
Well this is embarrassing...something went wrong. A team of highly trained monkeys has been dispatched to deal with this situation. Please try and reload this page.