CUSTOMER SERVICE +1 (855) 456-9276
FREE SHIPPING ON ALL U.S. ORDERS OVER $35*

Lowbrow Customs 39mm Fork Shrouds - Easy Install

lowbrowlogo-Lowbrow-Customs-Fork-Shrouds

Lowbrow Customs' 39mm Fork Shrouds clean up the look of your front end with real iconic style. All Lowbrow Customs 39mm Fork Shrouds include allen hardware for an E-Z bolt-on installation. This install does require you to remove and get rid of that front fender, but that's ok, your bike will look better without it. This also gives you an opportunity to clean up the lowers and shave down your fender tabs before putting things back together. Here are 10 easy steps on how to put our 39mm Fork Shrouds on your bike.

Before work is performed, make sure the front wheel is raised off the ground.

Remove the front fender.

IMG_5318-Lowbrow-Customs-Fork-Shrouds

Remove the brake caliper bolts. They require a 10mm 12 point socket, and then take the caliper off. Do not let it hang by the brake line.  A small bungee cord and a rag wrapped around the caliper works well.

IMG_5327-Lowbrow-Customs-Fork-Shrouds IMG_5328-Lowbrow-Customs-Fork-Shrouds

First loosen the axle nut, and then the pinch bolt in the bottom of the right fork lower leg, and remove the front wheel.

IMG_5333-Lowbrow-Customs-Fork-Shrouds

Loosen the top and bottom pinch bolts on the triple trees (one side at a time) and remove the bolts- be sure to hold the fork tube as it will fall out if not supported.

IMG_5335-Lowbrow-Customs-Fork-Shrouds

Slide the entire fork tube out of triple trees.

IMG_5340-Lowbrow-Customs-Fork-Shrouds IMG_5341-Lowbrow-Customs-Fork-Shrouds

Install the 39mm Fork Shroud. The spacers will go on the bottom; in-between the tab on the Fork Shroud and the bottom triple tree.

IMG_5350-Lowbrow-Customs-Fork-Shrouds

Slide tube back into the trees and check installed height of tubes at the top tree. Torque pinch bolts to factory specifications.

IMG_5344-Lowbrow-Customs-Fork-Shrouds

Repeat for other side.

Re-install wheel and brake caliper. Torque the front axle, being sure to follow the proper procedure in your workshop manual; then torque the brake caliper bolts.

IMG_5366-Lowbrow-Customs-Fork-Shrouds IMG_5363-Lowbrow-Customs-Fork-Shrouds

*Safety note: Make sure to pump the front brakes (if you are keeping them) a few times while it is still on the lift spinning the wheel by hand, making sure it spins and stops and everything is working correctly before riding.

426A9280-Lowbrow-Customs-Fork-Shrouds

Now you are looking good!

Check out the full install Video here

One thought on “Lowbrow Customs 39mm Fork Shrouds - Easy Install”

Leave a Reply
  •