Frames are EXCLUDED from the free shipping over $100.00 special
For more info on frame shipping see the Frame FAQ.
Full Triumph frames for unit motors custom-made by David Bird. These Triumph 500 c.c. / 650 c.c. / 750 c.c. frames are made from 1.5" x .120" wall and 1" x .120" wall DOM tubing with 5/16" thick axle plates. Beautiful TIG welds, MIG welded axle plates. The perfect platform for your Triumph bobber or chopper build.
These are available with your choice of either the looped or straight rear frame rails at the axle, and are available in 0", 2", 4", and 6" stretch. You can also choose 0", 1" or 2.5" of drop. The 2.5" drop is only available on the 4" and 6" stretch frames. The 500 c.c. frames are also available with 1" of drop, which can be seen in some of the photos below. Frames are made to accommodate a battery box or not, if you choose 'Add Base' the bends on the bottom rails will be pushed towards the rear so there is a flat base to mount your battery box.
NOTE: The steering neck used on these frames is the same as SKU# 001261 and will accept a pre-1970 stock Triumph front fork. Or with our bearing conversion kit SKU# 000328 you can put a front fork that has a 1 inch steering stem. If your Triumph front end is a 1971 and up, the steering stem is a smaller diameter and we do not have any bearing kits for that.
For more information and frequently asked questions about our custom frames and hardtails, please check out the Frame FAQ.
These are custom made-to-order and currently take approximately 2-4 weeks to complete and ship. You will be charged the shipping at the time of purchase, and when your frame ships we will email over your tracking info.
NOTE TO AUSTRALIAN CUSTOMERS: If you are in Australia be sure to read the frame FAQ, due to your country's customs laws all frames ship freight and there will be additional charges in addition to the shipping shown during checkout.
Allen - 12/06/2013
Pros - Beautiful welds, sex appeal, helpful if you aren't starting with a project bike
Cons - Absolutely none
My purchase was processed quickly for being "made to order." The frame was wrapped and highly protected during the shipping process. It's an eye catching frame, with welds that are flawless. I was looking for the custom look and it's provided with the options of "Stretch" and "Drop" The threaded bungs are made to slap your motor right in. I had no project bike to start with, so this was perfect for the bobber build. Don't start with crap, do yourself a favor and buy quality fab made in the USA! =D
Well this is embarrassing...something went wrong. A team of highly trained monkeys has been dispatched to deal with this situation. Please try and reload this page.