- Fits 1965-1984 Harley-Davidsons
- Custom polished variation of the traditional end bell regulators
- Low voltage model comes with a low voltage regulator specially tuned for a small 12-volt battery
- Higher service output than a stock generator
- Blacked out regulator and generator body
- 2 year Cycle Electric guarantee
- Made in the U.S.A.
If you need to replace the generator on your generator model Harley-Davidson motorcycle 1965 - 1984 this will do the trick. This is a complete charging system complete with regulator. This special edition brings a stock-like vintage look to your generator. Cycle Electric is now producing Mattias "Le Beef" Andersson's hand polished cast prototype in a limited run. State of the art technology meets Le Beef's inimitable style. The DGV-5000-CP offers a custom polished variation of our traditional end bell regulators. The smooth contoured fins pair particularly well with Knuckleheads, Panheads, and various custom bikes with its polished raw aluminum finish.
Higher service output than a stock generator backed by a 2 year Cycle Electric guarantee. Repair service is available after 2 years; this is the last generator you will ever need to buy for your bike. The ""L"" or low voltage model comes with a low voltage regulator specially tuned for a small 12-volt battery. This is especially important when using a small battery in a horseshoe oil tank. The low volt was designed for use when converting from a 6-volt system to a 12-volt system. These low voltage models also have Cycle Electric 'M' option which assures cradle clearance when installing on 1957 and earlier motors. There are two methods to mount a two-brush generator on 1957 and earlier motors. One is to enlarge the mounting holes in the engine case to fit the larger 5/16" bolts. The second method is to use helicoils to reduce the 5/16-24 threads in the mounting holes down to 1/4-24 and use the stock bolts. Made in the U.S.A. by Cycle Electric right here in Ohio!
Note: 1936-1957 When replacing 3 brush generators use #31035-58 oil deflector, discard spring and old deflector
Note: Check for clearance on foot clutch models. Over all length of DGV-5000 is 7.58 inches from gasket surface to fins.
Note: There are no returns on carburetors, electrical items, full frames, hardtails or made-to-order items (such as magnetos) unless there is a manufacturer’s defect.
